CABLE, Shift Interlock: Adjustments: Adjustment

WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Center Console Housing Screws

Courtesy of CHRYSLER LLC

Remove shift knob and shift bezel. Refer to Body/Interior/BEZEL, Shifter - Removal
Remove two screws (1).

Fig 2: Center Console
Courtesy of CHRYSLER LLC
Pull on side of housing (1) and unsnap housing tabs.
Disconnect console housing wire connector (2) and instrument panel connector (3).
Remove from vehicle.
Adjust interlock cable/system as follows: Pry up on cable adjuster lock to release and allow cable to "self-adjust". Lock cable adjustment by pressing down on the adjuster lock until bottomed at the cable housing.