LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Anti-Lock Brake System (Service Information)) >> Hydraulic/Mechanical >> Integrated Control Unit (ICU) >> Installation >> Right-Hand-Drive

Integrated Control Unit (ICU): Installation: Right-Hand-Drive

WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Integrated Control Unit Mounting - RHD
GC0098437Courtesy of CHRYSLER LLC
  1. Install the ICU with bracket (1) through the opening between the A/C lines and the exhaust manifold using the opposite of how it was removed.
  2. Install the ICU with bracket (1) into the engine compartment. Place the mounting bracket for the ICU (1) over the mounting stud and screw (3) and hang the assembly in place. Tighten the mounting nut (2) and mounting screw (3) to 23 N.m (17 ft. lbs.).
    Fig 2: ABM
    GC0081322Courtesy of CHRYSLER LLC
    1 - ABM (PART OF ICU)
    2 - WIRING HARNESS CONNECTOR
    CAUTION: Before installing the ABM harness connector on the ABM, be sure the seal is properly installed in the connector.
  3. Insert the ABM wiring harness connector (2) into the socket of the ABM (1) and close the cover, locking the connector in place.
    Fig 3: Brake Tubes At ICU
    GC0079880Courtesy of CHRYSLER LLC
  4. Install the four chassis brake tubes (2, 3, 5, 6) brake tubes at the ICU hydraulic control unit (7). Tighten the tube nuts to 17 N.m (150 in. lbs.).
  5. Install the primary (4) and secondary (1) brake tubes at the ICU hydraulic control unit (7). Tighten the tube nuts to 17 N.m (150 in. lbs.).
    Fig 4: Air Cleaner Assembly
    GC0098415Courtesy of CHRYSLER LLC
  6. Install the air cleaner housing (1). Refer to Engine/Air Intake System/BODY, Air Cleaner - Installation .
    Fig 5: Brake Pedal Holding Tool
    GC0098418Courtesy of CHRYSLER LLC
  7. Remove the brake pedal holding tool.
  8. Install the engine appearance cover.
  9. Connect the battery negative cable to the battery post. It is important that this be performed properly. Refer to Electrical/Battery System - Standard Procedure .
    Fig 6: Bleed Hose Set Up
    GC0079789Courtesy of CHRYSLER LLC
  10. Hook up the scan tool to initialize the ABM and perform the following:
    1. Clear any faults.
    2. Fill the master cylinder to the proper fill level and bleed the base and ABS hydraulic systems. See BASE BRAKE BLEEDING and Brakes - Standard Procedure .
    3. Check for leaks.
    4. Perform the ABS Verification Test and road test the vehicle. Refer to DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure .
scientia non olet · About LEMON Manuals