LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Anti-Lock Brake System (Service Information)) >> Electrical >> SENSOR, Wheel Speed, Rear >> Installation >> Front-Wheel-Drive

SENSOR, Wheel Speed, Rear: Installation: Front-Wheel-Drive

WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: FWD Rear Wheel Speed Sensor
GC0083950Courtesy of CHRYSLER LLC
  1. Install the wheel speed sensor head (3) into the rear of the hub and bearing (2).
  2. Install the wheel speed sensor head mounting screw (1). Tighten the screw to 10 N.m (89 in. lbs.).
    Fig 2: Rear Wheel Speed Sensor Mounting To Trailing Link
    GC0083966Courtesy of CHRYSLER LLC
  3. Position the wheel speed sensor (3) on the trailing link (2) and install the screw (4) securing it in place. Tighten the mounting screw to 18 N.m (13 ft. lbs.).
  4. Position the wheel speed sensor (3) and install the routing clip (1) fastening the sensor to the trailing link (2).
    Fig 3: Sensor Mounting To Rear Crossmember
    GC0098435Courtesy of CHRYSLER LLC
  5. Position the wheel speed sensor cable routing clamp (3) on the rear suspension crossmember (4) and install the mounting screw (1). Tighten the mounting screw to 18 N.m (13 ft. lbs.).
    Fig 4: Rear WSS Mounting To Body
    GC0083965Courtesy of CHRYSLER LLC
  6. Install the speed sensor cable routing clip (3) on the outside frame rail (4).
    NOTE: When inserting the wheel speed sensor cable through the hole in the body, route the cable toward the shock tower to make it easier to grasp the cable to connect it to the body wiring harness connector in a later step.
  7. Insert the wheel speed sensor cable (5) through the hole in the body (1) and install the grommet (2) in the hole.
    Fig 5: Tire & Wheel Mounting
    GC0084722Courtesy of CHRYSLER LLC
  8. Install the tire and wheel assembly (1). Refer to Tires and Wheels - Installation . Install and tighten the wheel mounting nuts (3) to 135 N.m (100 ft. lbs.).
  9. Lower the vehicle.
    Fig 6: Rear WSS At Harness Connector
    GC0098434Courtesy of CHRYSLER LLC
  10. Through the opening in the bottom of the quarter trim panel, connect the wheel speed sensor cable connector (2) at the body wiring harness connector (3).
  11. Install the cargo floor cover.
  12. Perform the Diagnostic Verification Test and clear any faults. See Brakes - Standard Procedure .
scientia non olet · About LEMON Manuals