Diesel Engine
WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - COOLANT RECOVERY PRESSURE CONTAINER |
| 2 - DASH PANEL |
| 3 - COOLANT HOSE |
| 4 - RETAINING BOLTS |
| 5 - RETAINING NUT |
- Partially drain cooling system using the draincock only. See Standard Procedure . Drain system below level of the coolant recovery pressure container.
- Remove engine cover.
- Disconnect hose and remove oil separator from top of valve cover.
- Remove fuel filter heater and position aside.
- Disconnect return hose at coolant recovery container (1).
- Remove coolant recovery container mounting bolts bolt.
- Lift container up at disconnect coolant hose from left side of coolant recovery container
- Remove coolant recovery container from engine compartment.