LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Lighting Systems - Exterior (Service Information)) >> LAMP, Park and Turn Signal >> Removal >> Lamp

LAMP, Park and Turn Signal: Removal: Lamp

WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Front Fog Lamp
GC0098542Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Raise and support the vehicle.
  3. Remove the front wheel and tire on the same side of the vehicle as the park/turn signal lamp being serviced. Refer to Tires and Wheels - Removal .
  4. Remove the three screws (1) that secure the outboard side of the front wheel house splash shield (4) to the front fascia (2).
  5. Remove the push pin fastener (3) that secures the inboard side of the splash shield to the front end sheet metal.
  6. Remove the two push pin fasteners that secure the forward edge of the splash shield to the front fascia closure panel.
  7. Fold the front of the splash shield rearward far enough to access the back of the front fascia.
    Fig 2: Park/Turn Signal Lamp
    GC0084756Courtesy of CHRYSLER LLC
  8. From the back side of the front fascia (4), disconnect the engine compartment wire harness (1) connector (3) from the park/turn signal bulb socket (2) connector receptacle.
  9. Remove the three screws (5) that secure the lamp to the back of the front fascia.
  10. Remove the lamp from the seat in the face of the fascia.
scientia non olet · About LEMON Manuals