LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (HVAC Systems (Service Information)) >> Distribution >> Housing, HVAC >> Installation >> Housing-Air Inlet

Housing-Air Inlet

WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: LHD model shown. RHD model similar.
Fig 1: Air Inlet Housing
GC0082721Courtesy of CHRYSLER LLC
  1. Install the air inlet housing (2) onto the top of the HVAC housing (3) and engage the two plastic retaining tabs (4). Make sure the retaining tabs are fully engaged.
  2. Install the four screws (1) that secure the air inlet housing to the HVAC housing. Tighten the screws to 1.2 N.m (10 in. lbs.).
  3. If equipped, install the particulate air filter. See Heating and Air Conditioning/Distribution/FILTER, Particulate Air - Installation .
  4. Install the HVAC housing assembly. See Heating and Air Conditioning/Distribution/HOUSING, HVAC - Installation .
scientia non olet · About LEMON Manuals