LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Rack & Pinion Power Steering System) >> Pump >> Removal >> Gas Engine

Gas Engine

WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before proceeding. See Warning  .
  1. Siphon as much fluid as possible from the power steering fluid reservoir.
  2. Remove the engine appearance cover.
    Fig 1: Power Steering Pressure Hose
    GC0082505Courtesy of CHRYSLER LLC
  3. Remove the pressure hose routing bracket bolt (2) at the upper mount (8).
  4. Remove the pressure hose (3) at the pump pressure port (5).
    Fig 2: Supply Hose
    GC0082520Courtesy of CHRYSLER LLC
  5. Remove the hose clamp (2) securing the supply hose (1) at the pump.
  6. Remove the supply hose (1) from the pump (3).
    Fig 3: Power Steering Pump - Gas
    GC0082521Courtesy of CHRYSLER LLC
  7. Remove the drive belt (2). Refer to Cooling/Accessory Drive/BELT, Serpentine - Removal
  8. Remove the three pump mounting bolts (1) through the pulley (3) openings.
  9. Remove the power steering pump.