LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Rack & Pinion Power Steering System) >> Pump >> Removal >> Diesel Engine

Diesel Engine

WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before proceeding. See Warning  .
  1. Siphon as much fluid as possible from the power steering fluid reservoir.
  2. Remove the engine appearance cover.
    Fig 1: Pump Pressure Line And Pump Pressure Port
    GC0082522Courtesy of CHRYSLER LLC
  3. Remove the pressure hose routing bracket bolt (2) to the upper mount (7).
  4. Remove the pressure hose (3) at the pump pressure port (4).
    Fig 2: Hose Clamp And Supply Hose
    GC0082523Courtesy of CHRYSLER LLC
  5. Remove the hose clamp (3) securing the supply hose (1) at the pump.
  6. Remove the supply hose (1) from the pump (2).
    Fig 3: Power Steering Pump - Diesel
    GC0082524Courtesy of CHRYSLER LLC
  7. Remove the drive belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Removal
  8. Remove the two pump mounting bolts (1) through the pulley (2) openings.
    Fig 4: Rear Pump Mounting Bolt - Diesel
    GC0082525Courtesy of CHRYSLER LLC
  9. Remove the rear pump mounting bolt (2) behind the pump (1).
  10. Remove the power steering pump (1).