LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Rack & Pinion Power Steering System) >> Pump >> HOSE, Power Steering, Pressure >> Removal >> Diesel Engine

Diesel Engine

WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before proceeding. See Warning  .
  1. Siphon as much fluid as possible from power steering fluid reservoir.
  2. Remove the engine appearance cover.
    Fig 1: Pump Pressure Line And Pump Pressure Port
    GC0082522Courtesy of CHRYSLER LLC
  3. Remove the pressure line (3) at the pump (4).
  4. Remove the pressure line routing bracket bolt (2) at the upper mount (7).
    Fig 2: Pressure Hose Bracket Routing
    GC0084375Courtesy of CHRYSLER LLC
  5. Remove the pressure line routing bracket bolt (1) at the back of the engine (2).
    Fig 3: Return Hose At Return Tube
    GC0082526Courtesy of CHRYSLER LLC
  6. Raise and support the vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure
  7. Remove the return hose (1) at the return tube (2).
    Fig 4: Hoses At Left-Hand-Drive Gear
    GC0084370Courtesy of CHRYSLER LLC
  8. Remove the return tube (1) at the steering gear (3).
  9. Remove the pressure hose (2) at the steering gear (3).
    Fig 5: Power Steering Hose Routing Clamps To Crossmember
    GC0083855Courtesy of CHRYSLER LLC
  10. Remove the fasteners (1) securing the power steering hose routing clamps (2) to the crossmember.
  11. Remove the power steering pressure hose from the vehicle.