Exhaust Pressure Sensor
WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - ELECTRICAL CONNECTOR |
| 2 - PRESSURE DIFFERENTIAL SENSOR |
| 3 - MOUNTING BOLT |
| 4 - UPSTREAM PRESSURE TUBE |
| 5 - DPF |
| 6 - DOWNSTREAM PRESSURE TUBE |
| 7 - TUBING |
- Disconnect and isolate negative battery cable.
- Remove electrical connector at pressure differential sensor (2).
- Remove upstream exhaust pressure tube (4) from catalytic converter
- Remove downstream pressure tube (6) from catalytic converter.
- Remove pressure differential sensor mounting bolt.
- Remove pressure differential sensor (2) and tubing (7) from vehicle.
- Remove tubing (7) from pressure differential sensor (2).