Electronically Controlled Clutch (ECC)

U0100-LOST COMMUNICATION WITH ECM/PCM (TIPM)

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:

- With the ignition on
- Battery voltage between 10 and 16 volts
- IOD fuse installed
- TIPM is configured correctly
- Set Condition:
Bus messages not received from the ECM/PCM for approximately 2 to 5 seconds.





Refer to Communications Test for this DTC and/or Manufacturer Code Charts for diagnostic procedures and for further possible causes.

For a complete wiring diagram Consult Diagrams/Electrical.