Planetary GEARTRAIN
WARNING: This page is about a different variant/trim than selected.
NOTE:
Clean and inspect all components. Replace any components which show evidence of excessive wear or scoring.
| 1. Snap Ring | 4. Input Planetary Carrier |
| 2. Thrust Bearing No. 10 | 5. Input Sun Gear |
| 3. Input Annulus | 6. Reverse Carrier |
- Install the input sun gear (6) into the input carrier (5).
- Install the number 10 thrust bearing (2) onto the rear of the reverse planetary carrier (7) with the inner race toward the carrier.
- Install the number 9 thrust bearing onto the front of the reverse planetary carrier (7) with the outer race toward the carrier and the inner race facing upward.
- Install the reverse planetary gear carrier (7) into the input carrier (5).
- Install the input annulus gear (4) into the input carrier (5).
- Install the snap-ring (1) to hold the input annulus gear (4) into the input carrier (5).