Park Lock Cable

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Ignition Key/Switch Positions

Courtesy of CHRYSLER LLC

1 - LOCK

2 - ACC

3 - ON

4 - START

Place ignition key in the ACC (2) position. See Fig 1.

Fig 2: Park Lock Cable At Ignition Cylinder

Courtesy of CHRYSLER LLC

1 - RETAINER

2 - CONNECTOR

3 - IGNITION CYLINDER

4 - PARK LOCK CABLE

Remove the lower instrument panel trim as necessary to access the park lock cable.

Disconnect park lock cable (1) from ignition cylinder (2). See Fig 2.

Fig 3: Identifying Gearshift And Park Lock Cable At Shifter Assembly

Courtesy of CHRYSLER LLC

1 - SHIFTER ASSEMBLY

2 - ADJUSTMENT NUT

3 - SHIFT CABLE

4 - SHIFT CABLE ATTACHMENT

5 -PARK LOCK CABLE

Remove the floor console as necessary for access to the park lock cable. Refer to REMOVAL .
If necessary, remove the bolts holding the shield, covering the gearshift and park lock cables, to the shifter assembly and remove the shield.
Disconnect the park lock cable (5) from the shift mechanism. Release retention tab using suitable screwdriver. See Fig 3.