Transmission Solenoid/TRS Assembly

WARNING: This page is about a different variant/trim than selected.

NOTE: If the Transmission Solenoid/TRS Assembly is being replaced, the Quick Learn Procedure must be performed. Refer to STANDARD PROCEDURE .

Fig 1: Valve Body Bolts

Courtesy of CHRYSLER LLC

1 - VALVE BODY TO CASE BOLT (6)

Remove the valve body from the transmission. See Fig 1. See REMOVAL .

Fig 2: Transmission Solenoid/TRS Assembly Bolts
Courtesy of CHRYSLER LLC

1 - SOLENOID PACK BOLTS (15)
Remove the bolts (1) holding the transmission solenoid/TRS assembly onto the valve body. See Fig 2.
Separate the transmission solenoid/TRS assembly from the valve body.