LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Manifolds >> Manifold - Exhaust >> Removal >> Exhaust Manifolds >> Exhaust Manifold

Exhaust Manifold

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect negative battery cable.
  2. Raise vehicle.
  3. Remove exhaust pipe to manifold bolts.
  4. Remove engine mount to frame fasteners.
  5. Using suitable jack, raise engine enough to remove manifolds.
    CAUTION: Do not damage engine harness while raising the engine.
  6. Remove the engine mount. See REMOVAL .
    Fig 1: Exhaust Manifold Bolt Tightening Sequence - Left
    GC0004014Courtesy of CHRYSLER LLC
    Fig 2: Exhaust Manifold Bolt Tightening Sequence - Right
    GC0004013Courtesy of CHRYSLER LLC
  7. Remove heat shield.
  8. Remove manifold bolts using sequence provided.
  9. Remove manifold and gasket.
scientia non olet · About LEMON Manuals