LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Lubrication >> Pump-Engine Oil >> Installation >> Oil Pump

Oil Pump

WARNING: This page is about a different variant/trim than selected.
Fig 1: Removing/Installing Oil Pump
GC0003966Courtesy of CHRYSLER LLC
  1. Position the oil pump onto the crankshaft and install the 4 oil pump retaining bolts.
  2. Tighten the oil pump retaining bolts to 28 N.m (250 in. lbs.).
  3. Install the timing chain cover. See INSTALLATION .
  4. Install the pick-up tube and oil pan. See INSTALLATION .
scientia non olet · About LEMON Manuals