LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Engine Block >> Solenoid-MDS >> Installation >> MDS Solenoid

MDS Solenoid

WARNING: This page is about a different variant/trim than selected.
Fig 1: MDS Solenoids
GC0051334Courtesy of CHRYSLER LLC
  1. Verify that MDS bores are free of debris, before solenoid installation.
  2. Install MDS solenoid(s) (3) fully into block.
  3. Install hold down bolt (2) and tighten to 11 N.m (97 in. lbs.).
  4. Reconnect the MDS wiring harness to the solenoid(s) (3).
  5. Install foam insulator pad (1) if removed.
  6. Install the intake manifold. See INSTALLATION .
scientia non olet · About LEMON Manuals