LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Engine Block >> Seal-Crankshaft Oil-Rear >> Installation >> Crankshaft Oil Seal - Rear

Crankshaft Oil Seal - Rear

WARNING: This page is about a different variant/trim than selected.
Fig 1: Using Special Tools 8349 Crankshaft Rear Oil Seal Installer And C-4171 Driver Handle With Hammer To Tap Seal Into Place
GC0003985Courtesy of CHRYSLER LLC
1 - Special Tool 8349 and C-4171 handle
2 - Seal Guide
3 - Seal
CAUTION: The rear seal must be installed dry for proper operation. Do not lubricate the seal lip or outer edge.
  1. Position the plastic seal guide (2) onto the crankshaft rear face. Then position the crankshaft rear oil seal (3) onto the guide.
  2. Using Special Tools 8349 Crankshaft Rear Oil Seal Installer (1) and C-4171 Driver Handle, with a hammer, tap the seal (3) into place. Continue to tap on the driver handle until the seal installer seats against the cylinder block crankshaft bore.
  3. Install the flexplate. See INSTALLATION .
  4. Install the transmission.
scientia non olet · About LEMON Manuals