LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Engine Block >> Seal-Crankshaft Oil-Front >> Removal >> Crankshaft Oil Seal - Front

Crankshaft Oil Seal - Front

WARNING: This page is about a different variant/trim than selected.
Fig 1: Crankshaft Damper Removal
GC0003975Courtesy of CHRYSLER LLC
1 - 3-Jaw Puller 1023
2 - Crankshaft Insert 8513A
  1. Disconnect negative cable from battery.
  2. Remove accessory drive belt. Refer to REMOVAL .
  3. Drain cooling system. Refer to STANDARD PROCEDURE .
  4. Remove upper radiator hose.
  5. Remove radiator shroud attaching fasteners.
  6. Remove radiator cooling fan and shroud. Refer to REMOVAL .
  7. Remove crankshaft damper bolt.
  8. Remove damper using Crankshaft insert 8513A (2) and Three Jaw Puller 1023 (1). See REMOVAL .
    Fig 2: Using Crankshaft Front Seal Remover 9071 To Remove Crankshaft Front Seal
    GC0003982Courtesy of CHRYSLER LLC
    1 - Crankshaft Front Seal Remover 9071
    2 - Seal
  9. Using Crankshaft Front Seal Remover 9071 (1), remove crankshaft front seal (2).
scientia non olet · About LEMON Manuals