Crankshaft Oil Seal - Front

WARNING: This page is about a different variant/trim than selected.

Fig 1: Using Crankshaft Front Oil Seal Installer 9072 And Damper Installer 8512A To Install Crankshaft Front Seal

Courtesy of CHRYSLER LLC

1 - SPECIAL TOOL 8512A INSTALLER

2 - SPECIAL TOOL 9072 INSTALLER

CAUTION: The front crankshaft seal must be installed dry. Do not apply lubricant to sealing lip or to outer edge.

Using Crankshaft Front Oil Seal Installer 9072 (2) and Damper Installer 8512A (1), install crankshaft front seal.
CAUTION: To prevent severe damage to the Crankshaft or Damper, thoroughly clean the damper bore and the crankshaft nose before installing Damper.
Install vibration damper. See INSTALLATION .
Install radiator cooling fan and shroud. Refer to INSTALLATION .
Install upper radiator hose.
Install accessory drive belt refer. Refer to INSTALLATION .
Refill cooling system. Refer to STANDARD PROCEDURE .
Connect negative cable to battery.