LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Engine Block >> Retainer-Crankshaft Rear Oil Seal >> Removal >> Crankshaft Rear Seal Retainer

Crankshaft Rear Seal Retainer

WARNING: This page is about a different variant/trim than selected.
Fig 1: Rear Seal Retainer Torque Sequence
GC0003976Courtesy of CHRYSLER LLC
  1. Disconnect negative cable from battery.
  2. Remove the transmission.
  3. Remove the flexplate. See REMOVAL .
  4. Remove the oil pan. See REMOVAL .
  5. Remove the rear oil seal retainer mounting bolts.
  6. Carefully remove the retainer from the engine block.
scientia non olet · About LEMON Manuals