LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Engine Block >> Retainer-Crankshaft Rear Oil Seal >> Installation >> Crankshaft Rear Seal Retainer

Crankshaft Rear Seal Retainer

WARNING: This page is about a different variant/trim than selected.
Fig 1: Rear Seal Retainer Torque Sequence
GC0003976Courtesy of CHRYSLER LLC
  1. Thoroughly clean all gasket residue from the engine block.
  2. Use extreme care and clean all gasket residue from the retainer.
  3. Position the gasket onto the retainer.
  4. Position the retainer onto the engine block.
  5. Install the retainer mounting bolts. Tighten the bolts to 15 N.m (132 in. lbs.) using the procedure shown.
  6. Install the oil pan. See INSTALLATION .
  7. Install the flexplate. See INSTALLATION .
  8. Install the transmission.
  9. Check and verify engine oil level.
  10. Start engine and check for leaks.
scientia non olet · About LEMON Manuals