LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Engine Block >> Damper-Crankshaft >> Removal >> Crankshaft Damper

Crankshaft Damper

WARNING: This page is about a different variant/trim than selected.
Fig 1: Crankshaft Damper Removal
GC0003975Courtesy of CHRYSLER LLC
1 - 3-Jaw Puller 1023
2 - Crankshaft Insert 8513A
  1. Disconnect negative cable from battery.
  2. Remove accessory drive belt. Refer to REMOVAL .
  3. Drain cooling system. Refer to STANDARD PROCEDURE .
  4. Remove radiator upper hose.
  5. Remove fan shroud. Refer to REMOVAL .
  6. Remove crankshaft damper bolt.
  7. Remove damper using Crankshaft Insert 8513A and Three Jaw Puller 1023.
scientia non olet · About LEMON Manuals