LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Cylinder Head >> Inspection >> Cylinder Heads

Cylinder Heads

WARNING: This page is about a different variant/trim than selected.
  1. Inspect the cylinder head for out-of-flatness, using a straightedge and a feeler gauge. If tolerances exceed 0.0508 mm (0.002 in.) replace the cylinder head.
  2. Inspect the valve seats for damage. Service the valve seats as necessary.
  3. Inspect the valve guides for wear, cracks or looseness. If either condition exist, replace the cylinder head.
  4. Inspect pushrods. Replace worn or bent pushrods.
scientia non olet · About LEMON Manuals