LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (4.7L Engine (Service Information)) >> Manifolds >> Manifold - Exhaust Left >> Removal >> Left Exhaust Manifold

Left Exhaust Manifold

WARNING: This page is about a different variant/trim than selected.
Fig 1: Exhaust Manifold-Left
GC0003933Courtesy of CHRYSLER LLC
ITEM DESCRIPTION TORQUE ITEM DESCRIPTION TORQUE
1 Stud (Qty 2) 25 N.m (18 ft. lbs.) 4 Nut (Qty 2) 8 N.m (72 in. lbs.), then loosen 45 degrees
2 Bolt (Qty 4) 5 Nut (Qty 2)
3 Stud (Qty 2)
  1. Disconnect negative cable for battery.
  2. Hoist vehicle.
  3. Disconnect exhaust pipe at manifold.
  4. Lower vehicle.
  5. Remove air cleaner housing and tube.
  6. Remove the front two exhaust heat shield retaining fasteners (4). Raise vehicle and remove the fasteners at rear of heat shield (5).
  7. Remove heat shield.
  8. Lower vehicle and remove the upper exhaust manifold retaining bolts (1,2,3,).
  9. Raise vehicle and remove the lower exhaust manifold retaining bolts (1,2,3).
  10. Remove exhaust manifold and gasket. Manifold is removed from below the engine compartment.
scientia non olet · About LEMON Manuals