LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (4.7L Engine (Service Information)) >> Lubrication >> Switch-Oil Pressure >> Installation >> Oil Pressure Switch

Oil Pressure Switch

WARNING: This page is about a different variant/trim than selected.
  1. Install oil pressure sender.
  2. Connect oil pressure sender wire.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals