LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (4.7L Engine (Service Information)) >> Lubrication >> Pump - Engine Oil >> Installation >> Oil Pump

Oil Pump

WARNING: This page is about a different variant/trim than selected.
Fig 1: Primary Timing Chain Tensioner Bolt Tightening Sequence
GC0003857Courtesy of CHRYSLER LLC
  1. Position the oil pump onto the crankshaft and install one oil pump retaining bolt.
  2. Position the primary timing chain tensioner and install three retaining bolts.
  3. Tighten the oil pump and primary timing chain tensioner retaining bolts to 28 N.m (250 in. lbs.) in the sequence shown.
  4. Install the secondary timing chain tensioners and timing chains. See INSTALLATION .
  5. Install the timing chain cover. See INSTALLATION .
  6. Install the pick-up tube and oil pan. See INSTALLATION .
scientia non olet · About LEMON Manuals