LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (4.7L Engine (Service Information)) >> Lubrication >> Pump - Engine Oil >> Assembly >> Oil Pump

Oil Pump

WARNING: This page is about a different variant/trim than selected.
  1. Wash all parts in a suitable solvent and inspect carefully for damage or wear.
  2. Install inner and outer rotors
  3. Install oil pump cover plate and install cover bolts and tighten them to 12 N.m (105 in. lbs.).
  4. Prime oil pump before installation by filling rotor cavity with engine oil.
  5. If oil pressure is low and pump is within specifications, inspect for worn engine bearings or other causes for oil pressure loss.
scientia non olet · About LEMON Manuals