Engine Oil Pressure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Locating Oil Pressure Sending Unit, Connector & Oil Filter

Courtesy of CHRYSLER LLC

1 - BELT

2 - OIL PRESSURE SENSOR

3 - OIL FILTER

4 - ELEC. CONNECTOR

Remove oil pressure sending unit. See Fig 1 and install gauge assembly C-3292.
Run engine until thermostat opens.
Oil Pressure:
1. Curb Idle-25 Kpa (4 psi) minimum
2. 3000 rpm-170 - 550 KPa (25 - 80 psi)
If oil pressure is 0 at idle, shut off engine. Check for a clogged oil pick-up screen or a pressure relief valve stuck open.