LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (4.7L Engine (Service Information)) >> Engine Block >> Seal-Crankshaft Oil - Front >> Removal >> Crankshaft Oil Seal - Front

Crankshaft Oil Seal - Front

WARNING: This page is about a different variant/trim than selected.
Fig 1: Crankshaft Damper - Removal
GC0003821Courtesy of CHRYSLER LLC
1 - Crankshaft Insert 8513
2 - 3 Jaw Puller 1026
  1. Disconnect negative cable from battery.
  2. Remove accessory drive belt. Refer to REMOVAL .
  3. Remove A/C compressor mounting fasteners and set compressor aside.
  4. Drain cooling system. Refer to STANDARD PROCEDURE .
  5. Remove upper radiator hose.
  6. Disconnect electrical connector for fan mounted inside radiator shroud.
  7. Remove radiator shroud attaching fasteners.
    NOTE: Transmission cooler line snaps into shroud lower right hand corner.
  8. Remove radiator cooling fan and shroud. Refer to REMOVAL .
  9. Remove crankshaft damper bolt.
  10. Remove damper using Crankshaft Insert 8513 (1) and 1026 Three Jaw Puller (2).
    Fig 2: Crankshaft Front Seal Removal
    GC0003822Courtesy of CHRYSLER LLC
    1 - Crankshaft Front Seal Remover 8511
  11. Using Crankshaft Front Seal Remover 8511 (1), remove crankshaft front seal.
scientia non olet · About LEMON Manuals