LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (4.7L Engine (Service Information)) >> Cylinder Head-Right >> Cylinder Head Cover - Right >> Removal >> Right Cylinder Head Cover

Right Cylinder Head Cover

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect battery negative cable.
  2. Disconnect battery positive cable.
  3. Remove the battery tray.
  4. Drain cooling system. Refer to STANDARD PROCEDURE .
  5. Remove accessory drive belt. Refer to REMOVAL .
  6. Remove air conditioning compressor retaining bolts and move compressor to the left.
  7. Remove heater hoses.
  8. Disconnect injector and ignition coil connectors.
  9. Disconnect and remove positive crankcase ventilation (PCV) hose.
  10. Remove oil fill tube.
  11. Un-clip injector and ignition coil harness and move away from cylinder head cover.
  12. Remove right rear breather tube and filter assembly.
  13. Remove cylinder head cover retaining bolts.
  14. Remove cylinder head cover.
NOTE: The gasket may be used again, provided no cuts, tears, or deformation has occurred.
scientia non olet · About LEMON Manuals