Air Intake System - Installation

INSTALLATION

1. Install filter element into housing.
2. Position housing cover into housing locating tabs.
3. Pry up 4 spring clips and lock cover to housing.
4. Install air duct to air cleaner cover and tighten hose clamp to 5 Nm (45 in. lbs.) torque.
5. If any other hose clamps were removed from air intake system, tighten them to 5 Nm (45 in. lbs.) torque.
6. If any bolts were removed from air resonator housing or air intake tubing, tighten them to 5 Nm (45 in. lbs.) torque.