LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander 2WD V6-3.7L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Drive Belts, Mounts, Brackets and Accessories >> Drive Belt Tensioner >> Service and Repair >> Accessory Drive Belt Tensioner - Installation

Accessory Drive Belt Tensioner - Installation







3.7L





1. An indexing slot is located on back of tensioner (2). Align this slot to the head of the bolt on the front cover. Install the mounting bolt (1). Tighten bolt to 41 Nm (30 ft. lbs.).
2. Install drive belt Accessory Drive Belt - Installation.
scientia non olet · About LEMON Manuals