LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler V6-3.8L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Seals and Gaskets >> Rear Crankshaft Main Bearing Seal >> Service and Repair >> Removal

Removal






REMOVAL




1. Remove the transmission.
2. Remove the flex plate.
3. Insert a 3/16 flat bladed pry tool between the dust lip and the metal case of the crankshaft seal. Angle the pry tool through the dust lip against metal case of the seal. Pry out seal.

CAUTION: Do not permit the pry tool blade to contact crankshaft seal surface. Contact of the pry tool blade against crankshaft edge (chamfer) is permitted.
scientia non olet · About LEMON Manuals