LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Sahara, Standard >> Labor Times >> Other Variant >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the Wrangler Rubicon, Automatic, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
All1.8B
Front,Both Sides1.0B
Rear,Both Sides1.0B
Combination Procedure: AXLE OR WHEEL BEARING: Replace:
Rear,One Side0.6B
Combination Procedure: AXLE SEAL: Replace:
Rear,One Side0.6B
Combination Procedure: BRAKE HOSE: Replace:
Includes: Bleed Brake System.
Each Additional0.2B
One0.3B
Combination Procedure: CALIPER: Overhaul:
Includes: Bleed Brake System.
Front or Rear,Single Piston Calipers,One0.5B
Combination Procedure: CALIPER: Replace:
Includes: Bleed Brake System.
One0.3B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: DISC ROTOR: Correct:
Lateral Runout,EachCorrect Rotor lateral runout by indexing or correction plate.0.2B
Combination Procedure: HUB & ROTOR DISC: Clean & Inspect:
Corrosion,EachClean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor.0.2B
Combination Procedure: PARKING BRAKE SHOE & LINING: Replace:
Both SidesIncludes: R&I Axle Shaft. Includes: R&I Center Console.2.0B
Combination Procedure: WHEEL BEARING: Replace:
Front,OneIncludes: R&I Axle Shaft.0.4B