LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine & Automatic Transmission Cooling System) >> Standard Procedure >> Cooling-Filling

Standard Procedure: Cooling-Filling

WARNING: This page is about a different variant/trim than selected.
  1. Tighten the radiator draincock and the cylinder block drain plug(s).
  2. Fill system with an antifreeze mixture. Refer to DESCRIPTION . Fill the radiator to the top and install the radiator cap. Add sufficient coolant to the reserve/overflow tank to raise the level to the FULL mark.
  3. Operate the engine with both the radiator cap and reserve/overflow tank cap in place. After the engine has reached the normal operating temperature, shut the engine off and allow it to cool.
  4. Add coolant to the reserve/overflow tank as necessary. Only add coolant when the engine is cold. Coolant level in a warm engine will be higher due to thermal expansion. 
scientia non olet · About LEMON Manuals