Engine Coolant Thermostat-Removal-2.8L Diesel Engine
WARNING: This page is about a different variant/trim than selected.
| 1 - GASKET |
| 2 - THERMOSTAT HOUSING |
| 3 - BOLT(S) |
| 4 - BRACKET |
NOTE:
The thermostat is not serviced separately. The thermostat and housing must be replaced as an assembly.
- Disconnect negative battery cable.
- Remove engine cover. Refer to REMOVAL .
- Partially drain cooling system. See STANDARD PROCEDURE .
- Disconnect upper radiator hose and bypass hoses at thermostat housing (2).
- Remove thermostat housing retaining bolts, support bracket and housing from cylinder head, discard gasket.