Engine Coolant Thermostat-Installation-2.8L Diesel Engine
WARNING: This page is about a different variant/trim than selected.
| 1 - GASKET |
| 2 - THERMOSTAT HOUSING |
| 3 - BOLT(S) |
| 4 - BRACKET |
- Clean old gasket material from cylinder head and thermostat housing.
- Install thermostat housing with gasket and support bracket to cylinder head. Torque bolts to 28 N.m. (250 in. lbs.).
- Connect coolant bypass hose and upper radiator hose to thermostat housing.
- Refill cooling system. See STANDARD PROCEDURE .
- Install engine cover. Refer to INSTALLATION .
- Connect negative battery cable.