Water Pump-Installation-3.3/3.8L Engine
WARNING: This page is about a different variant/trim than selected.
| 1 - WATER PUMP HOUSING |
| 2 - SEAL |
| 3 - IMPELLER |
- Install new seal into water pump housing groove.NOTE: The water pump pulley MUST be positioned loosely between the pump housing and drive hub BEFORE water pump installation.
- Position the water pump pulley loosely between pump housing and drive hub.
- Install water pump and pulley to the timing chain case cover. Tighten water pump bolts to 12 N.m (105 in. lbs.).
- Position pulley on water pump hub. Install bolts and tighten to 28 N.m (250 in. lbs.).
- Rotate pump by hand to check for freedom of movement.
- Install the accessory drive belt. See INSTALLATION .
- Install drive belt shield.
- Fill the cooling system. See STANDARD PROCEDURE .