LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine & Automatic Transmission Cooling System) >> Accessory Drive >> Pulley-Idler >> Installation >> Idler Pulley-Installation-2.8L Diesel

Idler Pulley-Installation-2.8L Diesel

WARNING: This page is about a different variant/trim than selected.
Fig 1: Idler Pulley
GC0056735Courtesy of CHRYSLER LLC
  1. Install idler pulley and retaining bolt. Tighten bolts to 53 N.m (39 ft. lbs.)
  2. Install accessory drive belt. See INSTALLATION .
  3. Connect negative battery cable.
scientia non olet · About LEMON Manuals