LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine & Automatic Transmission Cooling System) >> Accessory Drive >> Belts-Accessory Drive >> Removal >> Accessory Drive Belts-Removal-3.8L

Accessory Drive Belts-Removal-3.8L

WARNING: This page is about a different variant/trim than selected.
Fig 1: Belt Tensioner - 3.3/3.8L
GC0024423Courtesy of CHRYSLER LLC
1 - BELT TENSIONER
2 - BOLT
CAUTION: Do not let tensioner arm snap back to the free arm position, severe damage may occur to the tensioner.
  1. Disconnect negative battery cable from battery.
  2. Rotate belt tensioner clockwise  until it contacts its stop. Remove belt, then slowly rotate the tensioner into the free arm position.
scientia non olet · About LEMON Manuals