LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (42RLE Automatic Transmission (Service Information)) >> 42RLE - Service Information >> Solenoid/Pressure Switch ASSY >> Removal >> Solenoid/Pressure Switch Assembly

Solenoid/Pressure Switch Assembly

WARNING: This page is about a different variant/trim than selected.
NOTE: If the Solenoid/Pressure Switch Assembly is being replaced, the Quick Learn Procedure must be performed. Refer to STANDARD PROCEDURE .
Fig 1: Solenoid Retaining Screws
GC0009592Courtesy of CHRYSLER LLC
1 - SOLENOID/PRESSURE SWITCH ASSEMBLY
2 - RETAINING SCREWS
  1. Raise vehicle on hoist.
  2. Remove valve body assembly from transmission. See REMOVAL .
  3. Remove Solenoid/Pressure Switch Assembly retaining screws (2) from solenoid. See Fig 1.
    Fig 2: Solenoid/Pressure Switch Assembly and Screen
    GC0009593Courtesy of CHRYSLER LLC
    1 - SOLENOID/PRESSURE SWITCH ASSEMBLY
    2 - VALVE BODY
    3 - SCREEN
  4. Remove Solenoid/Pressure Switch Assembly (1) and screen from valve body (2). See Fig 2.
scientia non olet · About LEMON Manuals