LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (42RLE Automatic Transmission (Service Information)) >> 42RLE - Service Information >> Removal >> Automatic Transmission

Automatic Transmission

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect battery negative cable.
  2. Raise and support vehicle.
  3. Disconnect and lower or remove necessary exhaust components.
  4. Remove engine-to-transmission bending braces or engine collar.
  5. Remove starter motor. Refer to REMOVAL .
  6. If transmission is being removed for overhaul, remove transmission oil pan, drain fluid and reinstall pan. See STANDARD PROCEDURE .
  7. Remove torque converter access structural collar.
  8. Rotate crankshaft in clockwise direction until converter bolts are accessible. Then remove bolts one at a time. Rotate crankshaft with socket wrench on dampener bolt.
  9. Mark propeller shaft and axle yokes for assembly alignment. Then disconnect and remove propeller shafts. Refer to REMOVAL .
  10. Disconnect wires from the input and output speed sensors. See Fig 1.
  11. Disconnect wires from the transmission range sensor and the solenoid/pressure switch assembly. See Fig 1 and Fig 2.
    Fig 1: Locating Input Speed, Output Speed & Transmission Range Sensors
    GC0009445Courtesy of CHRYSLER LLC
    1 - INPUT SPEED SENSOR
    2 - OUTPUT SPEED SENSOR
    3 - TRANSMISSION RANGE SENSOR
    Fig 2: Solenoid/Pressure Switch Assembly
    GC0009446Courtesy of CHRYSLER LLC
    1 - SOLENOID/PRESSURE SWITCH ASSEMBLY CONNECTOR
  12. Disconnect gearshift cable from transmission manual valve lever.
  13. Disconnect shift cable and electrical connector from transfer case.
  14. Support rear of engine with safety stand or jack.
  15. Raise transmission slightly with service jack to relieve load on skid plate and transmission support.
  16. Remove bolts securing rear support and cushion to transmission and skid plate. See Fig 3.
  17. Remove bolts attaching skid plate to frame and remove skid plate. See Fig 3. Refer to REMOVAL .
    Fig 3: Transmission Mount - Automatic Transmission
    GC0029734Courtesy of CHRYSLER LLC
    1 - TRANSMISSION SUPPORT BRACKET
    2 - AUTOMATIC TRANSMISSION
    3 - SKID PLATE
    4 - FRAME
    5 - TRANSMISSION MOUNT SUPPORT BRACKET
    6 - CUSHION
  18. Disconnect transfer case vent hose.
  19. Remove transfer case. Refer to REMOVAL .
  20. Remove fill tube bracket bolts and pull tube and vent hose out of transmission. Retain fill tube seal. Remove the bolt attaching transfer case vent tube to converter housing.
  21. Remove the fuel line bracket bolt.
  22. Disconnect fluid cooler lines at transmission.
  23. Remove crank shaft position sensor.
  24. Remove all converter housing bolts.
  25. Carefully work transmission and torque converter assembly rearward off engine block dowels.
  26. Hold torque converter in place during transmission removal.
  27. Lower transmission and remove assembly from under the vehicle.
  28. To remove torque converter, carefully slide torque converter out of the transmission.
scientia non olet · About LEMON Manuals