LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (42RLE Automatic Transmission (Service Information)) >> 42RLE - Service Information >> Diagnosis And Testing >> Hydraulic Pressure Tests - 42RLE >> TEST ONE - SELECTOR IN MANUAL 1 (1st Gear)

TEST ONE - SELECTOR IN MANUAL 1 (1st Gear)

WARNING: This page is about a different variant/trim than selected.
NOTE: This test checks pump output, pressure regulation and condition of the low/reverse clutch hydraulic circuit and shift schedule.
  1. Attach pressure gauge to the low/reverse clutch tap.
  2. Move selector lever to the MANUAL 1 position.
  3. Allow vehicle wheels to turn and increase throttle opening to achieve an indicated vehicle speed to 20 mph.
  4. Low/reverse clutch pressure should read 115 to 145 psi.
scientia non olet · About LEMON Manuals