LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.8L Engine (Service Information) >> Engine Block >> Oil Seal-Crankshaft-Front >> Removal >> Crankshaft Oil Seal - Front

Crankshaft Oil Seal - Front

Fig 1: Engaging tool On Front Seal
GC0064399Courtesy of CHRYSLER LLC
1 - SEAL
2 - SPECIAL TOOL 6341A
  1. Disconnect negative cable from battery.
  2. Remove accessory drive belt. Refer to REMOVAL .
  3. Remove crankshaft damper. See REMOVAL .
  4. Position Special Tool 6341A (2) on crankshaft nose. Carefully screw the tool into the seal (1) until it engages firmly. Be careful not to damage that crankshaft seal surface of cover
    Fig 2: Crankshaft Front Seal Removal
    GC0064400Courtesy of CHRYSLER LLC
    1 - SEAL
    2 - SPECIAL TOOL 6341A
  5. Remove oil seal (1) by turning the forcing screw until the seal disengages from the cover.
scientia non olet · About LEMON Manuals