LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.8L Engine (Service Information) >> Engine Block >> Oil Seal-Crankshaft-Front >> Installation >> Crankshaft Oil Seal - Front

Crankshaft Oil Seal - Front

Fig 1: Crankshaft Front Seal Installation
GC0064401Courtesy of CHRYSLER LLC
1 - SPECIAL TOOL C-4992-1
2 - SEAL
3 - SPECIAL TOOL C-4992-2
4 - CRANKSHAFT
  1. Position Special Tool C-4992-2 Guide (3) , on the crankshaft nose.
  2. Position new seal (2) over the guide with the seal spring in the direction of the engine front cover.
  3. Install seal using Special Tool C-4992-1 (1) until seal is flush with cover.
  4. Install crankshaft damper. See INSTALLATION .
  5. Install accessory drive belt. Refer to INSTALLATION .
  6. Lower vehicle and connect negative cable to battery.
scientia non olet · About LEMON Manuals