Camshaft & Bearings (In Block): Installation: Camshaft

Fig 1: Camshaft & Bearings

Courtesy of CHRYSLER LLC

1 - CAMSHAFT

2 - THRUST PLATE

3 - BOLT

4 - CAMSHAFT BEARINGS (SERVICED WITH BLOCK)

1. Lubricate camshaft lobes (1) and camshaft bearing journals (4) with engine oil.
2. Install a long bolt into the camshaft to assist in the installation of the camshaft.
3. Carefully install the camshaft (1) in engine block.
4. Install camshaft thrust plate (2) and bolts (3). Tighten to 12 N.m (105 in. lbs.) torque.
5. Measure camshaft end play. See SPECIFICATIONS . If not within specifications, replace thrust plate.
6. Install the timing chain and sprockets. See INSTALLATION .
   NOTE: When camshaft is replaced, all of the hydraulic lifters must be replaced.
   Fig 2: Lifter Lubrication Hole

   Courtesy of CHRYSLER LLC
7. Install the hydraulic lifters with lubrication hole in the upward position. See INSTALLATION .
8. Install the timing chain cover. See INSTALLATION .
9. Install the cylinder heads. See INSTALLATION .
10. Install the cylinder head covers. See INSTALLATION .
11. Install the lower and upper intake manifolds. See INSTALLATION .
12. Install the radiator and cooling fan.