LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 3.8L Engine (Service Information) >> Cylinder Head >> Springs-Valve >> Installation >> Valve Springs - Cylinder Head Off

Valve Springs - Cylinder Head Off

Fig 1: Identifying Spring Compressor & Adapter
GC0064364Courtesy of CHRYSLER LLC
1 - SPECIAL TOOL C-3422-D SPRING COMPRESSOR
2 - SPECIAL TOOL 8464 ADAPTER
  1. If removed, install a new valve stem seal. See INSTALLATION .
  2. Position valve spring and retainer on spring seat.
  3. Using Special Tool C-3422-D with 8464 Adapter, compress the spring only enough to install the valve retainer locks. Install valve retainer locks. See Fig 1.
    Fig 2: Identifying Valve Spring Height
    GC0064365Courtesy of CHRYSLER LLC
    1 - VALVE SPRING RETAINER
    2 - VALVE INSTALLED HEIGHT
    3 - CYLINDER HEAD SURFACE
    4 - VALVE SPRING SEAT SURFACE
    5 - VALVE SPRING INSTALLED HEIGHT
  4. Slowly release the spring tension. Ensure the retainer locks are seated properly. See Fig 2.
scientia non olet · About LEMON Manuals