LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Driveshaft & Universal Joints >> Differential & Driveline (Service Information) >> Front Axle - 186FBI >> Shafts-Axle >> Installation >> Axle Shaft

Axle Shaft

Fig 1: Axle Shaft
GC0063541Courtesy of CHRYSLER LLC
  1. Clean axle shaft and apply a thin film of Mopar Wheel Bearing Grease or equivalent to the shaft splines and seal contact surface.
  2. Install hub bearing and brake shield on axle shaft.
  3. Install axle shaft (2) with hub bearing (1) through steering knuckle and into differential side gears.
    Fig 2: Hub Bearing Bolts
    GC0063540Courtesy of CHRYSLER LLC
  4. Install three hub bearing bolts (1) through steering knuckle (2) and tighten to 102 N.m (75 ft. lbs.).
    Fig 3: Stub Shaft Nut
    GC0063539Courtesy of CHRYSLER LLC
  5. Install hub nut (1) on axle shaft (2) and tighten to 136 N.m (100 ft. lbs.).
  6. Install wheel speed sensor.
  7. Install brake components.
scientia non olet · About LEMON Manuals