LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Differential & Driveline (Service Information) >> Rear Axle - 198RBI >> Shaft-Axle >> Removal >> Axle Shaft

Axle Shaft

Fig 1: Cable At Support Plate
GC0063647Courtesy of CHRYSLER LLC
  1. With transmission in neutral, position vehicle on hoist.
  2. Remove brake caliper with adapter and rotor.
  3. Remove park brake cable (1) from support plate (2).
    NOTE: Park brake cables are self adjusting and must be locked out before removal.
    Fig 2: Rear Wheel Speed Sensor
    GC0063649Courtesy of CHRYSLER LLC
  4. Remove brake sensor harness (1) and remove sensor (2) from support plate.
    Fig 3: Axle Assembly
    GC0063693Courtesy of CHRYSLER LLC
  5. Remove axle retainer plate nuts.
  6. Pull axle shaft (1) with support plate, bearing and seal from axle tube (2).
scientia non olet · About LEMON Manuals